Shared Flashcard Set

Details

Salem 2013 SRO CERT
Service Water Bay In-take Objective Study Guide
17
Other
Professional
07/21/2013

Additional Other Flashcards

 


 

Cards

Term

Service Water 

 

Purpose

Definition
Serves as the ultimate heat sink between the plant and the Delaware river for various heat loads in the Auxiliary, Containment and Turbine Buildings.
Term
Design Basis
Definition

Located 200 yards from shipping lanes

 

Marine Dock bumpers prevent damage from barge collision

 

Seismic Class 1 structure

 

Designed for Delaware river level, PH, temperature and Chlorides

Term

Design Basis

 

 

Service Water Pumps

Definition

Minimum of 2 SW Pumps required for Safeguards

 

 3 Pumps per Bay / 2 Bays per unit

 

Pumps provide Screen Wash, Strainer Backwash, and cooling for the pump motor bearing oil cooler

 

Min River level = 76 feet for Pump suction 71' 3"

Term

In the event of an SEC Mode Op, What number of SW Pumps are required to start?

 

Name the Primary vs. the back up pump and the Bus that feeds them.

Definition

One Primary SW Pump from each Vital Bus will start if neither pump is running. The backup pump will start within 5 seconds in the event the primary pump fails to start.

 

Note: EDGcan support only one SW Pump per Bus

 

Unit 2 Primary SW Pumps: 21 (A), 24 (B), 25 (C)

Term

How many SW Pumps are required for minimum Safeguards Equipment to shutdown a unit Safely?

 

Minimum Safeguard Equipment?

Definition

2 SW Pumps

 

2 EDGs

1 CC HXs

3 CFCUs

1 Trian of ECCS components/Room coolers

 

NOT limited by any single failure

Term
What is the normal number of pumps running at full operation of the plant?
Definition

4 SW Pumps in service during the Summer

 

3 SW Pumps in service in the Winter

 

1 Pump in Auto for maximum heat loads

 

1 pump in Manual (OFF)

Term

What is the normal SW Header Pressure?

 

When will the Standby Pump Auto Start?

Definition

NHP = 105-125psi

 

SW Hi Pressure Alarm = 160psi

 

Auto start of the standby Pump = < 95.5

Term

State the purpose of the SW17 valves.

 

What is the effect on operability regarding the SW17s?

Definition

SW17 cross connect the SW baysand allow continued operation with any combination of pumps.

 

Closing either SW17 valves will isolate the bays and 1 nuclear Header MUST be declared inoperable. due to concerns with pump runout and loss of NPSH

Term
State the purpose of the SW308 and SW311 Valves.
Definition
Recirculation valves that provide minimum flow protection for the SW Pumps ensuring up to 3000gpm for 3 SW pumps by modulating to maintain 150 PSI in each bay.
Term
Name the 4 Modes of operation for the SW Travaling Screens.
Definition

Auto: Places Screens and Screen Wash in Automatic Control. Starts on >5" H2O Dp  runs for 22 Minutes. Trouble alarm @ >6" or longer run time than 22 min.

Start:  Bypasses the timer and starts the screens

Inch: Bypasses the timer and allows the operator to inch the screen forward

Test: starts and runs the screen for 22 minutes

Note: Screens will NOT start unless 55psi of Screen Wash Header is present.

Term
SW Pumps are designed to Pump...
Definition
10,000 gpm at 240' of Head
Term
State the purpose of the 4KV Test-Normal Key Switch and location.
Definition

Normal Operation: Key Switch selects 24 as the lead SEC pump.

 

4 Bay unavailable due to 4.0.5.P or 24 Pump and motor is uncoupled, the switch must be repositioned to Test, which reassigns 23 pump as the lead SEC pump

Term
SW Strainers start rotating in auto whenever...
Definition
the associated SW Pump starts.
Term
Strainer Backwash...
Definition

Normally, Begins @ 5psid and continues for 3 Minutes after reaching <4psid

 

Tech Specs require the Strainer to be run in AUTO

 

OHA alarms @ 8 psid

Term

SW 4 bay Isolation from the TGA Header occurs when...

 

SW 2 bay Isolation from the TGA Header occurs when...

Definition

23SW20 and 2SW26 Valves close.

 

21SW20 and 2SW26 Valves close.

Term
Spray wash Lines are protected from freezing by...
Definition
Isolation valves closing and drain valves opening.
Term

How does the SW strainer Normal/bypass switch effect the strianer blowdown?

 

How does Blowdown effect Chlorination?

Definition

If in Bypass the blowdown runs continuously.

 

When Blowdown is OOS, then Chlorination is OOS

Supporting users have an ad free experience!