The caliper is more accurate than a(n)_______ but less accurate than a micrometer.

The micrometer measures a dimension by holding the part between the _______ face and the spindle face.

barrel

width

anvil

The ________ is designed to keep the micrometer from overpressing the workpiece.

lever lock

friction sleeve

scale

The base length of a 3"- 4" micrometer is _______.

2"

4"

3"

The _______ scale allows a mircometer to read to the nearest 0.0001".

barrel

twelve

vernier

The thimble of the micrometer is graduated in ________ mm.

1/10

1/1000

1/100

The typical accuracy of an English micrometer is ________ inch(es).

1"

4"

0.0002"-0.0004"

The _______ of a part is measured with a micrometer by sweeping it to find the longest line.

diameter

frame

thimble

Micrometer are extremely accurate because they avoid the effects described by ______ Law.

Frank's

Abbe's

Sam's

The micrometer has very high accuracy because it has higher resolution, its part to be measured is ______ with the line of measurement and can apply consistent pressure to the workplace.

inline

laser

frame

The _________ of a dial indicator shows the number of times an indicator's needle has rotated around the dial face.

revolution counter

depth gauge

meter

The part of a dial indicator that rotates the dial face is called the _______.

carriage

dial

bezel

A dial indicator uses the _______ measurement method to determine length.

indirect

inside

total

The actual measurement of a dial indicator is equal to the _________ dimension plus the indicator measurement.

depth gauge

dial

reference

The two common types of indicators are dial and ________.

ruler

needle

digital

A digital indicator's readout shows the location of its _________ relative to the reference position.

probe

mastering

fixture

Giving a long push on the ______ button of a digital indicator will cause the display to be set to zero.

off

ten

on

A(n) _________ is the device on a modular gauge that causes the probe to extend and retract.

probe retractor

dial

needle

A 1-2-3 block is a(n) _________ that measures 1 inch by 2 inches by 3 inches.

fixture

needle

gauge block

_________ is the process of setting the indicator's readout to zero when the probe is in a known location.

Carriage

Zeroing

Mastering

The three ways to collect quality data are to use _________ hand-held data collectors, and stationary data acquisition equipment.

check sheets

historical

micrometer

Stationary data acquisition equipment is best used when ________ volumes of data are collected.

large

small

X-large

The Amatrol SPC Data Management software's default screen is divded into _______ main areas.

2

10

4

__________ are the maximum and minimum measurements that a part can have and still be considered a good part.

Historical

Direct

Specifications

hand-held data collectors

flat

traditional