Term
| There are multiple use cases in an ExtremeControl solution that require _____ from a user before they can be assigned the right level of access on the network |
|
Definition
|
|
Term
| Additional input required from a user is typically gathered via a captive portal served from the _____. |
|
Definition
|
|
Term
| The user's assigned _____ is used to decide if a user’s web traffic must be redirected to the captive portal or not. |
|
Definition
|
|
Term
| If a captive portal is required to gather a user’s input before being granted access, a _____ must be assigned to them. |
|
Definition
|
|
Term
| Once a user has provided the required information through the captive portal, they are re-authenticated and a _____ is assigned providing a specific level of access. |
|
Definition
|
|
Term
| _____ is a technique used by routers to override the existing route table of a router |
|
Definition
| Policy-based routing (PBR) |
|
|
Term
| One component of PBR is a definition of the traffic that will be routed differently. This is typically an _____. |
|
Definition
| Access Control List (ACL) |
|
|
Term
| One component of PBR is a routing override decision based on the traffic that was matched. This is typically a _____. |
|
Definition
|
|
Term
| One component of PBR is an interface in which to apply the route-map. This is typically assigned on a _____. |
|
Definition
|
|
Term
| The ExtremeControl solution utilizes PBR to override the current routing decisions for web traffic that needs to be redirected to the Access Control Engine’s captive portal. |
|
Definition
|
|
Term
| Because PBR will not match normal web traffic, redirection is accomplished by applying an explicit _____ value to the web traffic via an accept policy. |
|
Definition
|
|
Term
| What does DSCP stand for? |
|
Definition
| Differentiated Services Code Point |
|
|
Term
| If there are additional router hops between the router interface and the Access Control Engine, then PBR needs to be applied to _____. |
|
Definition
| every router interface in between |
|
|
Term
| When designing a PBR configuration, you should determine if DSCP is currently in use on the network. It's common for DSCP to be used in a(n) ______ network. |
|
Definition
|
|
Term
| When designing a PBR configuration, you should determine if there are other networking devices between the routers and the device that applied the DSCP value. If so, they may need to be _____ versus removing it from the traffic before it’s forwarded to the router. |
|
Definition
| configured to maintain the DSCP value that is assigned |
|
|
