Term
1. To test insulation for high resistance, grounds, and leakage,
what meter should you use? |
|
Definition
|
|
Term
| 2. A megger is prevented from exceeding its rated output voltage by the action of a |
|
Definition
|
|
Term
3. What term is used to define abnormal
resistance or impedance that
interferes with the normal signal
flow? |
|
Definition
|
|
Term
4. What instrument should you use to
troubleshoot fuel quantity coaxial
cables? |
|
Definition
| Time-domain reflectometer |
|
|
Term
5. Maximum deflection of the phase angle voltmeter occurs when what
phase relationships exists between
the two signals? |
|
Definition
|
|
Term
6. What type of voltmeter is a precision voltmeter that compares an unknown
voltage with an internal reference
voltage? |
|
Definition
|
|
Term
7. To be classified as a cable, a single conductor must have which of the
following characteristics? |
|
Definition
| insulated w/metallic Braided shield |
|
|
Term
8. When stamping wires or cables, the
distance between markings should not
exceed what maximum distance? |
|
Definition
|
|
Term
9. When used on aircraft electrical wiring, the recommended power rating
range for general-use soldering irons
is within which of the following
ranges? |
|
Definition
|
|
Term
| 10. Shielded conduit should be supported by the use of what type of clamp? |
|
Definition
|
|
Term
11. What type of safety wire should you
use to secure an oxygen regulator? |
|
Definition
|
|
Term
12. When long runs of cable between panels need to be supported, which of
the following types of clamps is
preferred? |
|
Definition
|
|
Term
13. If an aircraft were improperly bonded, which of the following
conditions would exist? |
|
Definition
| increased risk of lightening strikes |
|
|
Term
| 14. A primary objective of bonding is to provide an electrical path of... |
|
Definition
| low dc resistance and low RF impedance |
|
|
Term
When using methyl chloroform to clean electrical equipment, you should
remove the equipment from the
solution within what maximum length
of time? |
|
Definition
|
|
Term
16. When a printed circuit is manufactured by the photoetching
process, what portions of the
plastic or phenolic sheet are
actually photographically exposed? |
|
Definition
| areas covered by light sensitive enamel |
|
|
Term
| 17. When performing a functional ground test of the EGT system, heat for the thermocouples is provided by… |
|
Definition
|
|
Term
| 18. The generation of static electricity on an object by rubbing is known as… |
|
Definition
|
|
Term
19. Under which of the following conditions is generated static
electricity decreased? |
|
Definition
|
|
Term
20. What is the lowest voltage that will destroy or damage an ESD-sensitive
device? |
|
Definition
|
|
Term
| 21. Which of the following is NOT an ESD prime generator? |
|
Definition
| Carbon impregnated polyethylene |
|
|
Term
22. What is the minimum resistance for
personnel ground straps? |
|
Definition
|
|
Term
23. Which of the following procedures
should NOT be performed when working
on ESD-sensitive devices? |
|
Definition
| dielectric strength tests |
|
|
