Shared Flashcard Set

Details

G2 C Operating Procedures
G2 C Operating Procedures
11
Other
Not Applicable
02/26/2013

Additional Other Flashcards

 


 

Cards

Term
G2C01 -Which of the following describes full break-in telegraphy (QSK)? A. Breaking stations send the Morse code prosign BK B. Automatic keyers are used to send Morse code instead of hand keys C. An operator must activate a manual send/receive switch before and after every transmission D. Transmitting stations can receive between code characters and elements
Definition
(D)
Term
G2C02 -What should you do if a CW station sends "QRS"? A. Send slower B. Change frequency C. Increase your power D. Repeat everything twice
Definition
(A)
Term
G2C03 -What does it mean when a CW operator sends "KN" at the end of a transmission? A. Listening for novice stations B. Operating full break-in C. Listening only for a specific station or stations D. Closing station now
Definition
(C)
Term
G2C04 -What does it mean when a CW operator sends "CL" at the end of a transmission? A. Keep frequency clear B. Operating full break-in C. Listening only for a specific station or stations D. Closing station
Definition
(D)
Term
G2C05 -What is the best speed to use answering a CQ in Morse Code? A. The fastest speed at which you are comfortable copying B. The speed at which the CQ was sent C. A slow speed until contact is established D. 5 wpm, as all operators licensed to operate CW can copy this speed
Definition
(B)
Term
G2C06 -What does the term "zero beat" mean in CW operation? A. Matching the speed of the transmitting station B. Operating split to avoid interference on frequency C. Sending without error D. Matching your transmit frequency to the frequency of a received signal.
Definition
(D)
Term
G2C07 -When sending CW, what does a "C" mean when added to the RST report? A. Chirpy or unstable signal B. Report was read from S meter reading rather than estimated C. 100 percent copy D. Key clicks
Definition
(A)
Term
G2C08 -What prosign is sent to indicate the end of a formal message when using CW? A. SK B. BK C. AR D. KN
Definition
(C)
Term
G2C09 -What does the Q signal "QSL" mean? A. Send slower B. We have already confirmed by card C. I acknowledge receipt D. We have worked before
Definition
(C)
Term
G2C10 -What does the Q signal "QRQ" mean? A. Slow down B. Send faster C. Zero beat my signal D. Quitting operation
Definition
(B)
Term
G2C11 -What does the Q signal "QRV" mean? A. You are sending too fast B. There is interference on the frequency C. I am quitting for the day D. I am ready to receive messages
Definition
(D)
Supporting users have an ad free experience!