Term
What type of equipment can be worked on with Type III certification? |
|
Definition
|
|
Term
As of... the sale of CFC and HCFC refrigerants is restricted to certified technicians. |
|
Definition
|
|
Term
Because a low‐pressure system operates below atmospheric pressure (in a vacuum), leaks in the gaskets or fittings will cause... |
|
Definition
air and moisture to enter the system. |
|
|
Term
The most efficient method of leak checking a charged low-pressure refrigeration unit is to |
|
Definition
pressurize the system by the use of controlled hot water or heater blankets |
|
|
Term
When pressurizing a system, do not exceed |
|
Definition
|
|
Term
When leak testing a water box, be certain the water has been removed before... |
|
Definition
placing the leak detector probe through the drain valve. |
|
|
Term
To leak test a tube, use a... |
|
Definition
hydrostatic tube test kit. |
|
|
Term
Systems with open drive compressors are prone to leaks at the ... |
|
Definition
|
|
Term
What can be used to pressurize a chiller system before opening the system for a non-major repair? |
|
Definition
|
|
Term
After reaching the required vacuum on an appliance when servicing, moisture is indicated by; |
|
Definition
multiple rises in pressure over a period of time with increase of pauses between rises |
|
|
Term
EPA required evacuation levels for recovery or recycling equipment manufactured or imported before Nov. 15, 1993 is |
|
Definition
|
|
Term
EPA required evacuation levels for recovery or recycling equipment manufactured or imported on or after Nov. 15, 1993 is |
|
Definition
|
|
Term
Refrigerant recovery from a system using R-11 or R-123 starts with |
|
Definition
liquid removal and is followed by vapor recovery |
|
|
Term
If a strong odor is detected during the recovery process, |
|
Definition
a compressor burn out may have occurred |
|
|
Term
When installing more than one pressure relief valves must be installed; |
|
Definition
|
|
Term
The owner must keep records of refrigerant added during service and maintenance on equipment; |
|
Definition
with charges of 50 lbs or greater |
|
|
Term
After all the liquid has been removed from an average 350 ton approximately how much vapor refrigerant remains in the system |
|
Definition
|
|
Term
When charging a system with a low pressure refrigerant should be introduced as a vapor to raise saturation temperature to a minim of; |
|
Definition
|
|
Term
Where is the purge unit located in a low-pressure system? |
|
Definition
|
|
Term
In a chiller air and other noncondensables collect; |
|
Definition
at the top section of the condenser |
|
|
Term
A rupture disk for low pressure chiller will rupture at; |
|
Definition
|
|
Term
The Standard for machine room safety is; |
|
Definition
|
|
Term
Who establishes the refrigerant safety group standard |
|
Definition
|
|
Term
A low pressure chiller used for comfort cooling must be repaired if it has an annual leak rate of ____ of the total charge. |
|
Definition
|
|
Term
ASHRAE 34 Standard Safety classifies R-134a as; |
|
Definition
|
|
Term
Because a low-pressure system operates below atmospheric pressure (in a vacuum), |
|
Definition
leaks in the gaskets or fittings will cause air and moisture to enter the system |
|
|
Term
To repair a chiller operating with R-22 the technician; |
|
Definition
must have a type II certification |
|
|
Term
Which of the following refrigerants has a safety classification of B-1 |
|
Definition
|
|
Term
During evacuation of systems with large amounts of water, it may be necessary to; |
|
Definition
increase pressure by introducing nitrogen to counteract freezing |
|
|
Term
When leak testing a low pressure chiller, the maximum pressure to use is; |
|
Definition
|
|